All-welded heat exchanger structureThe welded plate heat exchanger is mainly composed of: heat transfer plates, welded end plates, pressure plates at both ends, clamping bolts, etc.A, heat transfer plateThe heat transfer plate is the main heat exchanger element, generally corrugated into a herringbo
18
2022-11
Difference between plate heat exchangers and fully welded plate heat exchangersPlate heat exchangerA plate heat exchanger is a highly efficient heat exchanger made from a series of metal plates with a certain corrugated shape. A thin rectangular channel is formed between the various plates and heat
16
2022-11
Fully welded plate heat exchangers All-welded plate heat exchanger product overview. All-welded plate heat exchanger absorbs the advantages of detachable plate heat exchanger and makes up for the shortcomings of tubular heat exchanger new high-efficiency heat transfer equipment, based on the o
03
2022-11
The brazed plate heat exchanger is made of many stamped corrugated sheets at certain intervals, sealed around by gaskets, and overlapped with a frame and a compression screw. The four corner holes of the plate and the gasket form the separation of the fluid. At the same time, the cold and hot fluids
28
2022-06
Where are air preheaters generally used?Adapt to the environment: coal-fired boilers, gas-fired boilersAdapt to flue gas temperature: boiler room with flue gas temperature higher than 120℃Application principle of air preheaterDuring the operation of the boiler, it is necessary to discharge flue gas
13
2022-04
The flue gas produced by the hazardous waste incineration power plant is at a temperature of 50-70 °C after wet deacidification, and is in a saturated water state. Direct emission will corrode the flue and chimney, and produce white smoke at the chimney discharge. Therefore, it is necessary to use s
International Business:+86 0519 8878 2189
Domestic business:+86 0519 8878 2190